Hi all,
I have an a pillar problem, being that I need a new drivers side base where it meets the heater channels.
Are they even made and fairly easy to install?
Thanks
Nobody can drive you crazy, unless you give them the keys.
You mean its rusted out?
First off i'd hit it with the wire brush either on the grinder or the drill then post a photo to see how much you actually need to replace.
I've replaced both lower A pillars on mine and its not the easiest of jobs 🥲
Cheers
well if I remove the bog in it the a pillar would have about a 3.5 inch gap as there is no metal left, the person who did it was nice enough to clean the edges up and rust-proof it so it is only that spot. I can't get photos yet as I broke my phone it is getting repaired so photos to come in about 2 or 3 days.
Thanks
Nobody can drive you crazy, unless you give them the keys.
Actually probably about Sunday night really as I get back from my holiday then.
Nobody can drive you crazy, unless you give them the keys.
Futue te ipsum!!!
VVDS have replacement section that is best quality
what year is the body shell ????
1967 on the vin
Nobody can drive you crazy, unless you give them the keys.
