If you are using a ball joint front end off-road you need to add limiters so that the ball joints don't get pulled out or damaged. The idea here is to give you as much travel as possible and limit the travel just before the Ball joint binds.
To set it up it is best to do it with out torsion bars in as it makes it easier to feel the binding of the ball joint. Simply jack up the front and keep feeling the stub for easy movement, when it gets tight this means the ball joint is binding, back it off 5mm and set you limiters there.
I have played with a lot of designs for these and have found the following to be the easiest and quickest to fit.
Using some 50 x 6 mm strap cut a 2" hole through it. Then shape the other end into a curve.
Test fit and make any changes to get a snug fit.
Then simply take it in place and add a piece of 40 x 6mm angle to act as a stopper. You will see from the angle here that it doesn't line up exactly. This is because I allow for a 6mm strip of rubber to stop any banging noise.
Then pull it all apart and fully weld it up. Allow to cool and then clean it up paint it and get out there and play.
Brad Wolfsburg Elder
3,764 posts · joined Aug 2002 ·
