Is there anyway I can align the clutch when i re-install it with out one of these?
If it's imperitive that I use one, can I borrow one off someone?
Cheers
[Edited on 18-10-2004 by oval TOFU]
...and Robert's ya father's brother...
peice of bar the same size as the hole will do it .....
or the input shaft from an old gearbox.
hmmm... i dont have any pieces of bar that diameter... anyone got a piece of input shaft?! I've got one, but its kinda attached to a gearbox and a pair of axels!
🙂
[Edited on 18-10-2004 by oval TOFU]
...and Robert's ya father's brother...
hehe a drill bit? the shaft end? be creative...... otherwise a junker box may be cheaper than buying the tool :p
use a drill bit that fits the spigot bearing and wrap tape around it until it fits the clutch. Instant tool.......
kkk
curtain rod dowell, leg odd the ole dressing table ??
or pvc pipe as long as you get close to the diameter ie roll on masking tape to get the right thickness
Karmen
56 oval resto 60 Cal KG
58 & 62 beetle parting. 74 panel parting
63 Baja 80 GLD parting
58 donor split 11 window 63 Splitty sgle cab /son's
96 Seat Cordoba GLX daily drvr.
lol
They are some great ideas! Thanks people! I'll try em out and see how it goes...
this forum rocks! YOU GUYS ROCK!
...and Robert's ya father's brother...
I made one and I think I worked...
...and Robert's ya father's brother...
