vwking Officially Full-On Dubber
294 posts · joined Jun 2003 ·
does anyone know the part number for a vdo oil pressure gauge sender unit its for a 1600 vw motor
vdo oil pressure gauge sender unit
Andy Andy\'s Adventures
2,820 posts · joined Nov 2002 ·
231.085 or 231.089
here's their catalogue:
http://www.siemensvdo.com.au/files/2388_VDO%20CATALOGUE.pdf
see page 53. It's a 3 meg file though.
:blah
here's their catalogue:
http://www.siemensvdo.com.au/files/2388_VDO%20CATALOGUE.pdf
see page 53. It's a 3 meg file though.
:blah
type3lover in the garage...
796 posts · joined Feb 2005 ·
I assume you are after a sender for a gauge and not a switch...
I think they come in 500kpa and 1000kpa range and must be matched to the gauge you are using. Most engines will be the 500kpa unless they have a high volume oil pump fitted. Hope this helps.
Sorry, don't know the part # though.
Cheers!
Tobynn[ Edited on 14-7-2005 by type3lover ]
I think they come in 500kpa and 1000kpa range and must be matched to the gauge you are using. Most engines will be the 500kpa unless they have a high volume oil pump fitted. Hope this helps.
Sorry, don't know the part # though.
Cheers!
Tobynn[ Edited on 14-7-2005 by type3lover ]
.
vwking Officially Full-On Dubber
294 posts · joined Jun 2003 ·
cheers thanks for your help:beer
kombipom Casual Dubber
42 posts · joined Sep 2004 ·
Sorry to highjack with a dumb question but:
I've got VDO oil pressure and temp gauges in the kombi ('74, 1800 motor) but they dont work, where would I find the sender(s), assuming there are any, so that I can wire them up?
I've got VDO oil pressure and temp gauges in the kombi ('74, 1800 motor) but they dont work, where would I find the sender(s), assuming there are any, so that I can wire them up?
blutopless2 DAMSLO
2,457 posts · joined Jan 2004 ·
depends on how the people have installed the senders... the usual spot for the oil sender is on the left hand side of the motor. the oil pressure switch should already be installed there and you can get adapters to screw both the switch and the sender into the same take off point of the motor. then just run the wire(s) to the dash. The temp one it will depend again where they put it. some pull out the sump plug and screw a sender in there. there may be a few other places to put them too. you'll just have to have a look at the motor and see if you can find them.
good luck
good luck
see.... air and water do mix 😉
1974 1300
1997 MK3 Golf GL
2003 NB Cabrio
2012 Golf VI GTI
2014 Audi A4 Quattro
1974 1300
1997 MK3 Golf GL
2003 NB Cabrio
2012 Golf VI GTI
2014 Audi A4 Quattro
DallanMulley Seriously Crusin Dubber
145 posts · joined Apr 2004 ·
My temp sender is taped into the crankcase.