flat_iv Seriously Crusin Dubber
107 posts · joined May 2005 ·
Anyone have any good tips on how to remove a wire/pin from the main ecu connector to another hole in the connector. Any info would be greatly appreciated.
ECU pin/wire removal
Jenny Officially Full-On Dubber
352 posts · joined Jun 2003 ·
Most of the pins have a tang that comes out at an angle and hooks onto part of the plastic connector housing. Depending on the type, you either have to depress that tang or the plastic part of the housing from the front or rear of the connector whilst pulling on the pin/wire. I normally use a jewelers screwdriver to do this but have found a steel wire sometimes works as well.
1303Steve Scirocco Rare
8,650 posts · joined Aug 2002 ·
Hi
You can buy special tools to do this, try Dick Smith etc
Steve
You can buy special tools to do this, try Dick Smith etc
Steve
flat_iv Seriously Crusin Dubber
107 posts · joined May 2005 ·
Thanks guys, but I tried to remove thr wire and relocat it. But I just destroyed an old connector, salvaged a wire and inserted it into the ECM connector.
[ Edited on 13/1/2006 by flat_iv ]
[ Edited on 13/1/2006 by flat_iv ]