Skip to content
Aussieveedubbers

argh... can\'t get the EJ on

0 likes
Share Share on Facebook Share on X Share on Reddit
Log in to reply

72RSbug Officially Full-On Dubber

266 posts · joined Jan 2005 ·

#485485
had the EJ20TT on a swing axle box on my other pan, no problem.

Now I have a type 1 IRS box on an automatic pan and I keep having a 1cm gap between the engine and the box :cry

I can wiggle the engine left and right so the point where something is holding it back is in the center.

Already tried it without the clutch guidance tube and same problem. Als tried turning the crank slightly with each turn.

What to do next?

1303Steve Scirocco Rare

8,650 posts · joined Aug 2002 ·

#485486
Hi

Have you tried backing off the clutch cable?

Steve

72RSbug Officially Full-On Dubber

266 posts · joined Jan 2005 ·

#485487
The pedal set is not yet mounted on this chassis to there is nothing pulling the clutch lever.

seagull Compulsive Aussie Vee Dubber

4,979 posts · joined Dec 2003 ·

#485492
where are you , gee I ask this a lot of times
Looking for that special lady : PM me for coffee & cake

72RSbug Officially Full-On Dubber

266 posts · joined Jan 2005 ·

#485497
where are you
I live in Belgium.

I've measured the length and diameter of the gearbox shaft and it should fit. Think the bearing where the gearbox shaft sits in the flywheel might be the problem (I just put a plastic clutch allignment tool in it and that was a very tight fit.

seagull Compulsive Aussie Vee Dubber

4,979 posts · joined Dec 2003 ·

#485498
not this guy ?

1 attachment · Log in to view

Looking for that special lady : PM me for coffee & cake

seagull Compulsive Aussie Vee Dubber

4,979 posts · joined Dec 2003 ·

#485499
who made the adapter kit for you ?
Looking for that special lady : PM me for coffee & cake