Turkeyss Seriously Crusin Dubber
132 posts · joined Jun 2007 ·
Turkeyss Seriously Crusin Dubber
132 posts · joined Jun 2007 ·
MISS VDUB Administrator Mrs KOMBIBOB
2,565 posts · joined Sep 2005 ·
OZ Towdster Keen to finish some projects
1,921 posts · joined Dec 2003 ·
blutopless2 DAMSLO
2,457 posts · joined Jan 2004 ·
Turkeyss Seriously Crusin Dubber
132 posts · joined Jun 2007 ·
Spellbound Seriously Crusin Dubber
151 posts · joined Nov 2005 ·
Wish i had all that info before I bought my Bug. The pillars and pan I knew about, but the engine checks probably would have been a good idea.A Westwood wrote:Body ~ Take a fridge magnet with you to check for rust in the rear pillars as if there is any filler in this area it wont stick and as Ash said have a good look at the underside of the pan,and the bottom of the A pillars under the bottom hinges.
Apart from the body i would also give the mechanicals a good check out also as a dodgy gearbox alone will soon set you back a $1000 +
Gear box ~ They will always wine in reverse as they have straight cut teeth but if it pops out of reverse or any other gear its buggered
Motor ~ Being a 74 it should be fitted with a 1600 twin port but buy now it could be anything , so here are a couple of simple little tests once warm let it idle and remove the oil filler cap if it smokes exsesivly again its buggered and will cost $1500 + to rebuild to basic specs .Next turn it off and grab hold of the bottom fan belt pulley and give it a good pull back and forth and you should feel very close to no movement so know if thats good and it does not breath heavily i would now check for bad oil leaks which if it is a few years old will more than likely be leaking from the pushrod tubes which are under the cylinders and while looking in this area look up between the cylinder and cylinderhead which should be nice and dry but if it looks wet and oily it could posiibly have a compresion leak and another common bad leak will be the rear main seal which if stuffed will be leaking out between the gearbox and the motor at the bottom of the bellhousing.
Last of all have good look at the ball joints , tie rod ends and what the brakes feel like.
Now what have you found .
[ Edited on 6-9-07 by A Westwood ]
Turkeyss Seriously Crusin Dubber
132 posts · joined Jun 2007 ·
LukeV85 P Master
154 posts · joined Sep 2007 ·
Turkeyss Seriously Crusin Dubber
132 posts · joined Jun 2007 ·
LukeV85 P Master
154 posts · joined Sep 2007 ·