ok, 1300 engine. Failing to run on #2 and #4 cylinders.
2 rear cylinders (back of vehicle) for some reason.
Have checked valve clearences, have checked plug gaps, there is spark there. Leads are new. Cap looks to be ok.
What are compressions ment to be?
Any ideas?
1958 Beetle, 1966 VW Beetle, 1996 Holden Statesman!
Its an obsesion for engines and fuel.... 😏
have u checked the timing all leads in the right place could be a cracked cap
👍👍😂🙅🥷😬🤓
sounds like the leeds are on the wrong way around as per above
What did you do to the engine before this started to happen
the compression is approx 120 to around 140psi and as long as all 4 are approx close it will be good if one was only 60psi and the others were 130 psi then u have problems
Since ive had the car i've changed plugs and leads.
I've checked leads 3 times. all correct, firing order is correct. no evidence of damage to the dizzy cap.
rotor button is good. Ive also cleaned the carby.
Other than that its still original.... :S
1958 Beetle, 1966 VW Beetle, 1996 Holden Statesman!
Its an obsesion for engines and fuel.... 😏
firing order 1 4 3 2
i'm over it! AGHHH! Engines coming out for rebuild!
perhaps extreme, but atleast i'll know everythings right!
1958 Beetle, 1966 VW Beetle, 1996 Holden Statesman!
Its an obsesion for engines and fuel.... 😏
have you dont a compression test B4 u start to rip it apart