I have a CB lonkage but I am getting fed up with one carb opening a fraction before the other.
The standard steel one had wear in it so I replaced it with an aluminium one with steel inserts
Does anyone sell the CSP or Berg here in Australia before I go ordering from overseas.
Futue te ipsum!!!
you have to adjust linkage with someone operating the throttle from the drivers seat, as it is a different action from pushing the linkage on the engine and trying to adjust it that way.😊
😂🤪😂🤪😂
car forums. where a lot of peoples good intentions end up taking a good old car off the road forever never ever to see the road again. 🥲
just go straight to bergs.....phone them as they are currently doing a few different versions with stainless, chrome or painted bits and bobs............and have it by the end of the week
what is Bergs post rates like?
reasonable or in CB stratosphere?
Futue te ipsum!!!
Post rates all good!
Mmmm I need to ring Bergs to get one too 🙂
Only way to go.
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
Matt - you ever used the CSP??
Futue te ipsum!!!
No mate
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
wasn't someone modifying hexbar linkages so they swung in needle bearings?
to eliminate the wear/movement?
My uncle modified his hex bar to run in bearings and it works a treat. I modified a linkage kit for idf's to fit drla's. You need to buy throttle arm spacers so that the push arms both push in the same arc. Since I've done that they dint go out of adjustment!!
ACCEPT THAT SOME DAYS YOU ARE THE PIDGEON AND SOME DAYS YOU ARE THE STATUE
Alder Outlaws VW Racing - check it out on fb!!
make sure u roll pin the throttle arm clamp linkages when u finnish ur adjustments will never move again Cheers Rudi
