did a drivers side a pillar inc. heater channel and hinge.
Brace up the body and dash prior to cutting to maintain body geometry/shape as its a structural panel.
Take careful note of position, such as that the lower hinge is out forward enough to make sure the door when closing doesn't end up kissing the door sill everytime you close it. Make sure it doesn't go too far out either.
Do note that some aftermarket repair panels are made a bit 'cheaply'. the metal band/clip that holdes the hinge bolt threads is soemtimes only gently tack welded to the point a few knocks in the process of fitting can break the weld. It would be a real bugger if that hinge thread plate fell out with the a pillar already fitted. Be a nasty 'fishing out' job.
Other than that, have fun 👍
(ô_!_/ô) (ô_!_/ô)
69' baja: kombi box, thing spindles, irs, disc front, type 3 rear drums, 2 inch lift kit, 31x10 rears. 👍
New engine in process: 94mm p&bs, 74mm C/w chomol Crank, 35.5x39 SP heads, turbo. Wierd combo, hopeful torque monsta!
