Having a bit of a clear out so got some bits to sell. All is bulky so prefer pick up (except the tailpipe and lid lock which shipping is included)
I'll be at Rouse Hill on Sunday for the Big Blue so can take there if pre-arranged.
Otherwise pick up is from Kellyville Ridge, 2155
Reply here or PM me
Thanks, Keith
49 - 52 Split Beetle fuel tank. very good condition. Its been cleaned up and primed ready for the top coat. I've checked inside with an endiscope and all good though before using, probably a good idea to use a sealer.
Comes with a very good 100mm cap - $300
CB performance 2 1/2 inch dropped spindles for ball joint front end including inner & outer wheel bearings and track rod ends. Spindles were bought by me 2nd hand with only about 1000miles on them. I bought the bearings and track rod ends new - Set up was fitted and driven around the block before being taken off again cos the car was too low (because of the adjusters being welded in to get it on the ground, couldn't drive it even with them wound all the way up!)
$180 for the full set up
Euro tuck away dual exhaust. Brand new, never used. Paper still on the chrome on one side. A few storage scratches, otherwise spotless
$100 (muffler only - no header)
T34 razor edge engine lid. Really good condition. I assume the yellow is OG but not certain. Underside is black. Drip tray still fitted with seal in very good condition. Close up shows the only bit of rust along one edge which really isn't bad at all
$250
3 hub caps. OK condition, suit a Rat - $20 SOLD
Bay Window NOS tail Pipe part number 211 251 237B Still got the Part label on it. $40 shipped within Aus
Splitty engine lid lock (none key type), Part number 113827503E/F. Fits Beetle 67-71 or Splitty 67 only. Chrome is excellent condition
$40 shipped within Aus
Finally a couple of tool boxes free to whoever wants them. One by Kennedy and one by Roebuck (complete with various stickers inc a samba circa 1990's 😀 ) TAKEN
ovalkeith Seriously Crusin Dubber
101 posts · joined Jul 2007 ·
