As stated above I require in good condition (🤪) a firewall panel as above. The previous one was botched by the panel beater - not repairable.
I don't want the VW repro one (for later models) as it is totally different
If someone knows of a supplier that makes the early one I am all ears.
Name: Marcus Vass
Location: sitting down and facing forward in Springfield QLD 4300
Price: YTM
Contact: Mobile 0427 857002 or email/pm
Thanks
Have an early 60's one. Whats the difference?
Customer service is not dead in Australia.
Always after HAZET & MATRA & VW factory tools
Early 60's may be fine.
The repro is like one from the '70's with a lot of other pressings. It looks like this.
The early one is like this one.
I am no expert in the differences but would like the "plainer" pressing.
Very happy if yours is like that Marcus (from one Marcus to another)
👍
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
Time is ticking marcus.. only 363 days to have that thing running..
VW Toys
64 Beetle - club car - Herbie
RSK 718 Porsche Spyder
76 Southern Cross Offroad racing buggy. "Manx Buggies"
77 Cobra Offroad racing buggy "RipOff"
68 Country Buggy KO200
64 Manx swb
70 Dual Cab kombi
74 Dual Cab kombi
74 Micro bus
Marcus,
I have a "fair" one from a '58 that you can have.
Grahame
Grahame
visit my club site at
www.vwdcqinc.org.auHi Grahame
You are a gentleman as always.
Do you have a pic? (not wanting to be cheeky)
Ta
Marcus
Marcus (luftmeister) do you have a pic also of the engine firewall you have?
Anyone else either have something or know of a supplier.
I just want to check out all options as my panel beating ability is non existent. (that means it will cost for all repair/mod 🙂 )
tick
tock
tick
tock
tick
tock
😂😂😂
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
Plenty down here Marcus .... Shoulda asked a couple weeks ago!
Will check this arvo for you.
Customer service is not dead in Australia.
Always after HAZET & MATRA & VW factory tools
pic sent
Grahame
visit my club site at
www.vwdcqinc.org.auThis is mine. heater channels up to rear vents.
Customer service is not dead in Australia.
Always after HAZET & MATRA & VW factory tools
Bump
Still on the look out for one
The better the condition so there is less panel beating is my preference
I am happy to pay up to $200 for a very straight and clean one
