Skip to content
Aussieveedubbers

Cant open bonnet Its open now !!!!

0 likes
Share Share on Facebook Share on X Share on Reddit

57 oval Oval type 4 Fuel Injected

184 posts · joined Feb 2008 ·

#942027
Fitted the bonnet latch on the Oval yesterday, checked everything was working, cable pulling OK, latch operating OK, shut the bonnet now I cant get it open. The cable still apears to be working OK but the latch is not releasing. Tried the someone pull the cable whilst I tried lifting the bonnet but no good. Any clues as to how to get it open ???
1957 Oval type IV
1956 Oval poss project
1954 Oval impossible project
Ass 70's Beetles
http://www.users.on.net/~rogerbyrne/index.htm

sander288 "Bolt-on Master"

1,404 posts · joined Aug 2008 ·

#942028
I just had to reef on mine to get it to open when this happened; you've then got to adjust the tension on the spring underneath so that when you pull the cable it actually pops.
BMW R65 LS
1967 1300 Deluxe
Swing-axles FTW ❗

OZ Towdster Keen to finish some projects

1,921 posts · joined Dec 2003 ·

#942029
Push the nose of the bonnet left and right and back as the lip on the lock pin may be stuck under the lip of the catch as well as the releasing part of the catch
Don't let body work get in the way of real suspension travel

HappyDaze Superannuated

2,887 posts · joined Jun 2009 ·

#942030
Try bumping the bonnet side-ways, one side at a time, with the palm of your hand, while pulling on the handle. The rubber seals must be in place, otherwise the flange on the bonnet can get caught on the retaining strip for the rubber. If all else fails, you may have to saw the handle in two, and unscrew each half.

When you get it open, loosen the two bolts that hold the handle so that the catch inside will JUST slide up and down. With someone holding the release out, close and open the bonnet a few times....this should align the 'dog's dick'. Tighten the two screws, and then pray.
I'd rather wear a Beetle out by racing it than by polishing it!

vw54 Administrator Always Waiting 4 Friday

16,723 posts · joined Aug 2002 ·

#942042
pull the cabel out and lock it off with vice grips

them wriggle and push bonnet as per above

fall else failes get a hacksaw n cut the handke in half and unscrew it from the attach 6mm bolts
I read it on FACEBOOK so it must be true


http://forums.aussieveedubbers.com/viewtopic.php?tid=91278&page=1#pid848630


http://forums.aussieveedubbers.com/viewtopic.php?tid=63561&page=1#pid624099


http://forums.aussieveedubbers.com/viewtopic.php?tid=4832&page=1#pid452603


http://forums.aussieveedubbers.com/viewtopic.php?tid=60650&page=1#pid574409

57 oval Oval type 4 Fuel Injected

184 posts · joined Feb 2008 ·

#942052
Got it open, popped the little inspection plate off on the inside of the spare wheel well and managed to get the four bolts undone that hold the catch to the body. Thanks to all that replied
1957 Oval type IV
1956 Oval poss project
1954 Oval impossible project
Ass 70's Beetles
http://www.users.on.net/~rogerbyrne/index.htm