Lateral Wolfsburg Wizard
480 posts · joined Sep 2011 ·
Complete turnkey EFI System for VW motor - $1,950.00.
This custom setup was originally installed on the 1916cc motor that was in Stenguns Blue 1967 Beetle and is no longer needed as a new motor running dual carbies has been installed.
Everything was working perfectly prior to removing it as I drove the car from Brisbane to Sydney with no problems.
Absolutely everything (including a short wiring loom, new looms can be easily purchased) is there to provide a turnkey system...apart from the obvious need to set it up properly and tune it.
The ATOM G4 (http://www.linkecu.com/products/engine-management-ecus/g4_atom) is a highly configurable ECU and is configured by downloading the free software from the LinkECU website. All documentation is available free from the website also.
I have used their Customer Support as I wanted to find out more about the Atom G4 (they are based in New Zealand) and I have to say that they were really fantastic.
The following parts are shown in the attached photo:
1. Custom made Plenum x 1
2. CB Injector inlet manifolds x 2
3. Injectors x 4 (Serviced and flowed at 142cc per minute)
4. Fuel Rails x 2
5. Cold Start circuit x 1
6. KN Style air cleaners x 2
7. 60 mm Single Throttle Body
8. Scat degree pulley fitted with Crank Trigger Wheel x 1
9. Crank trigger sensor x 1
10.Atom G4 ECU with mounting bracket x 1
11.New Injector connectors and boots x 4
12.NEW TPS x 1
13.New Air Temp Sensor x 1
14.Coil pack x 1
15.Piersburg EFI Electric Fuel pump x 1
16.Oil Temp Sensor x 1 (With mounting plate)
17.Fuel regulator x 1
18.Air Cleaner manifold x 1
19.Miscellaneous aluminium tube connection pieces
20.Wiring loom-shortend (not shown as I just found it-21/07/2014)
Some interesting things to note:
1. The Atom G4 price new is about $1,200.00
2. The cost of the new TPS was $170.00
3. The cost of the new Air Temp Sensor was $61.00
4. The cost of the injector service etc was $230.00
This comes to more than $1,600.00!
As you can see from the above, the $1,950.00 asking price is somewhat of a bargain.
Everything is located in Sydney (Willoughby) and I am more than happy to arrange postage if needed.
Thanks guys
Regards
Greg
2 attachments · Log in to view