Interested in hearing some feedback/experiences - As I am looking do what has already been done in the following link: http://www.volksbolts.com/faq/gearbox-rear.htm
Similar to the above, I already have the CB rhino mounts - what I am look to achieve is to simply replacing the factory original cradle (that fits to the frame horns and holds the trans from the bottom) with the HD empi bottom mount - NOT THE STRAP, similar to the link above, to help support a bigger motor and new trans.
Simply speaking what I want to do is - retain my CB Rhino mounts & use the bottom of the empi HD trans mount; my question is: will the empi HD mount give me grief?
The reason for these specific parts to be used and not more full on tech is because it isn't a drag car and its pretty low, so I figure I can replace what is nackked, support the new set up and retain most of the ground clearance, and retain drive quality.
Ideally; ground clearance similar to the bellow image (although the image has a solid mount set up - no padding- from my research the ground clearance should be the same)
Your constructive feedback is welcomed
Thanks Dubbers
DreamWeaver Seriously Crusin Dubber
173 posts · joined Apr 2008 ·
WTD OG Carpet or OG tan square weave supplier
