Pedals

shep1969 Learner Dubber

5 posts · joined May 2013 · 7 May 2016, 8:02 pm

#1026051

Hi guys

Could someone please tell me how the pedal assembly comes out of my country buggy floor pan.
The assembly is very rusty and I'm struggling to see where the 2 sides seperate to remove from the tunnel.

Thanks Paul

bevoracing Officially Full-On Dubber

327 posts · joined Jan 2009 · 8 May 2016, 8:12 am

#1026063

Hi Paul
They can be a bit tricky with a lot of rust.
There is a bracket on the right, near the accelerator, with bolts through the plate on the floor pan.
The plate with the 2 bolts on the right hand side of the floor pan is just a support. Remove the bolts and the plate lifts up and out.
The plate with the 2 bolts on the left hand side of the floor pan is a bush with a circlip on the outside. Take the bolts out, remove the circlip and the lever, it just “slips” off the accelerator shaft (in your dreams) heat it with the oxy. Then the support plate slides off.
In these pictures it’s a CB pedal but not a CB chassis. You’ll get the idea. Sorry, no picture of the left hand side.
Good luck, don’t force it.
Cheers
Tony

3 attachments · Log in to view

Country Buggy King & Link Pin Overhauls, Type 1 & 2 King Pins, General Machining.
http://forums.aussieveedubbers.com/viewtopic.php?tid=74138
My car is KO813

shep1969 Learner Dubber

5 posts · joined May 2013 · 8 May 2016, 5:22 pm

#1026082

Thanks thats spot on what i needed

The accelerator arm on the lhs was as you said super tight

I have it apart now and soaking to eat the rust too see what can be saved

Thanks Paul

ztnoo Insano Dub Head

730 posts · joined Aug 2007 · 17 Jun 2016, 10:26 pm

#1027282

Outstanding pics there, Tony!

Fine tuning the proper daily ratio of Maxwell House to Bacardi 151.........

* Don't worry about the world coming to an end today. It's already tomorrow in Australia !