1300 cases gasket question ??

seagull Compulsive Aussie Vee Dubber

4,979 posts · joined Dec 2003 · 24 Jul 2004, 1:42 am

#207025

I rebuilding a 1300 cc case ,looking the the 6 of 12mm case bolts there is no taper at the base of the case for the O ring to sit in , this is the seal to stop oil going up the case bolts .

was this a change made to cases later on ?

ideas

Looking for that special lady : PM me for coffee & cake

seagull Compulsive Aussie Vee Dubber

4,979 posts · joined Dec 2003 · 25 Jul 2004, 9:19 pm

#207862

must be a hard one me think !

Looking for that special lady : PM me for coffee & cake

1303Steve Scirocco Rare

8,650 posts · joined Aug 2002 · 25 Jul 2004, 10:47 pm

#207947

Hi

It was a later innovation, just make sure you put some sealant on the nuts. A man with your talent be able to retrofit.

1302Steve

seagull Compulsive Aussie Vee Dubber

4,979 posts · joined Dec 2003 · 25 Jul 2004, 11:02 pm

#207951

Yes I counter sunk some O ring groves steve , should be good for 30 years more running .

lots of small changes over the years , making things better .

Looking for that special lady : PM me for coffee & cake

Che Castro ankle straps

1,945 posts · joined Aug 2002 · 26 Jul 2004, 9:31 am

#208017

a little dab of sealant on the washer and nut works well. Just make sure it isnt the type that goes hard

Jon

1303Steve Scirocco Rare

8,650 posts · joined Aug 2002 · 26 Jul 2004, 9:52 am

#208024

Hi

I always use Curil in cases like this.

1302Steve