Push Rod Tube

ashman Casual Dubber

23 posts · joined Nov 2004 · 18 Apr 2005, 3:56 pm

#339365

Hi guys, I've got a crack in a push rod tube (1976 Kombi with 2L twin carbs) that's pissing a bit of oil. Obviously this "total-loss lubrication system" isn't that bad but one day it could get worse so I'd like to fix it.

Can anyone provide me with a bit of guidance on this?

Anyone recommend that I weld/solder the crack up?

Anyone recommend that I attempt to put a sleeve around the tube and clamp it in place?

How much would a new/old one be?

What things should I look out for when I take the head off?

Do I HAVE to drop the donk to take the head off? I know this may seem like a silly question but I don't have a trolly jack and would rather not have to take the motor out without one.

Any other pointers or problems I should look out for?

Thanks heaps guys, I really appreciate it.

Ash

Kombi Project: http://ash.anu.edu.au/kombi

toplessbug Fahrvergnugen

879 posts · joined Aug 2002 · 18 Apr 2005, 8:38 pm

#339563

no need to any of that just take off the rocker cover and you will see a long spring holding the pushrod tubes in place remove it then remove the offending tube and replace it easy fix no need to remove engine or heads ..while you are in there i would do all the seals on both sides as it wont take long and its good insurance..

ashman Casual Dubber

23 posts · joined Nov 2004 · 19 Apr 2005, 8:30 am

#339777

That's great news guys, thanks for the heads (he he) up!

I'm going to dive in and do it this Saturday.

Kombi Project: http://ash.anu.edu.au/kombi