End float???

Andy42 Insano Dub Head

709 posts · joined Mar 2003 · 12 May 2003, 6:47 pm

#46603

How much end float is acceptable in a type 4 crank(1800).

KruizinKombi Seriously Obsessed Cyber Dubber

3,493 posts · joined Aug 2002 · 12 May 2003, 6:55 pm

#46608

0.07-0.13mm (0.0027-0.005 in) taken at No. 1 bearing.

Kruizin Kol

KruizinKombi Seriously Obsessed Cyber Dubber

3,493 posts · joined Aug 2002 · 12 May 2003, 6:56 pm

#46609

Oops, wear limit is 0.15mm (6 thou). 🙂

Kruizin Kol

Andy42 Insano Dub Head

709 posts · joined Mar 2003 · 12 May 2003, 6:58 pm

#46610

OH so if I can move the crank back and forward about three mm that must be ..... well....stuffed

KruizinKombi Seriously Obsessed Cyber Dubber

3,493 posts · joined Aug 2002 · 12 May 2003, 7:05 pm

#46617

Ah.... yeah :o

I've never been in that situation, but maybe some bearings might help?

Kruizin Kol

vw54 Administrator Always Waiting 4 Friday

16,723 posts · joined Aug 2002 · 12 May 2003, 8:20 pm

#46671

I would say that the case will need maching as well.

but more than likely its stuffed altogether as the thrust surface on the number one bearing will be gone.

I read it on FACEBOOK so it must be true

http://forums.aussieveedubbers.com/viewtopic.php?tid=91278&page=1#pid848630

http://forums.aussieveedubbers.com/viewtopic.php?tid=63561&page=1#pid624099

http://forums.aussieveedubbers.com/viewtopic.php?tid=4832&page=1#pid452603

http://forums.aussieveedubbers.com/viewtopic.php?tid=60650&page=1#pid574409