help; route of wiring loom into engine bay

oldnslo Seriously Crusin Dubber

162 posts · joined Feb 2005 · 26 Jul 2007, 6:07 pm

#603941

Im in the process of replacing the wiring loom and having problems pulling it thru the roof channell without getting it snagged on something inside the roof section, if I look inside the engine bay up towards the roof channel there is an oval shaped hole(no not the back window) punched out of the steel roof section on rhs. Is this where the cable goes thru and comes out into engine bay?

pod i`ve got to finish this thing one day

4,980 posts · joined Dec 2003 · 26 Jul 2007, 7:09 pm

#603950

try the left hand side(passenger) thats the way they run:thumb

[ Edited on 26-7-07 by pod ]

meetings 1st sunday of the month
check wbsite for location
All Welcome
http://www.flatfour.org/
and on Facebook https://www.facebook.com/FlatFour

57oval Officially Full-On Dubber

305 posts · joined Oct 2006 · 26 Jul 2007, 8:02 pm

#603959

Yes the cable goes thru that hole up into the channel. you can use a bit of yellow tongue off flooring boards to feed up into the channel

oldnslo Seriously Crusin Dubber

162 posts · joined Feb 2005 · 30 Jul 2007, 5:44 pm

#604499

thanks 57 oval, I used some of that yellow flexi stuff you said and threaded it thru the hole there and worked a treat, cable definetly came down drivers side channel.
Cheers mate.

Turbo54 Veteran Volks Folk

2,220 posts · joined Jul 2004 · 1 Aug 2007, 3:35 pm

#604757

Stuff that, I ran it through my drivers heater channel, Much neater look under the bonnet and engine bay.
T54

C'mon kids gather round,
there's a new sensation hitting town,
It's moving straight, low to the ground,
it'll pick you up when your feeling down.