Skip to content
Aussieveedubbers

Tappet cover tool for Kombis?

0 likes
Share Share on Facebook Share on X Share on Reddit
Log in to reply

Phil74Camper Head in the Clouds

2,703 posts · joined Aug 2002 ·

#666579
Is there a special bent tool to remove the (very strong) tappet cover retaining springs on 2-litre Kombis?

My old heads and springs were tired, and could easily be removed and replaced with a largish screwdriver. It was tricker than a Beetle as the heater boxes are bigger and get in the way, but not impossible.

However the new engine, with new heads and covers, has VERY strong springs. I did manage to get them off and on for tappet adjustment (with a big screwdriver and some swearing), but it is easy to get it wrong and a less than perfect fit results in an oil leak.

I'm told there's a VW tool that is like a curved screwdriver. What does it look like, so I can make one?

PurpleT3 Fahrvergnugen

880 posts · joined Apr 2003 ·

#666587
I use a brake adjusting tool which can be bought cheap from Supercheap or Autobarn. It is basically a bent screwdriver.
Ain't nothin' like the wind in your hair.

1303Steve Scirocco Rare

8,650 posts · joined Aug 2002 ·

#666620
Hi

I've used 1/2 of a pair of old multi grips, it lifts the clip, but also pushes down on the cover at the same time. So is it running or what?

Steve

Phil74Camper Head in the Clouds

2,703 posts · joined Aug 2002 ·

#666925
Yes all finished, took a lot longer than I thought it would. Had battery, then carb problems, but sorted now.

Half multigrips is good idea, will see if I have an old set somewhere. Leigh suggested making a tool out of a bent 8mm case stud, with a wooden file handle on one end - another good idea. I'll do the tappets again in another 1000 km so I'll also browse Supercheap next week...

h fractals - an ever changing lifestyle

7,671 posts · joined Feb 2005 ·

#667014
i use a bent screw driver n it works without fail everytime..
save ya pennys n bend an old one ya have lyin around..
cheers h
fractal geometry; the inner most limits of mind altering abuse

Fantasy http://seventhchronicle.com

Z = Z2 + C1/r = 1/0 = infinity

Barrels www.barrelman.com.au

VW Workshop - aircooledgarage.com.au
allcooled.com.au

General_Failure Use your head, don't abuse it!

1,036 posts · joined Jun 2004 ·

#667042
I have a 12" pinch bar that I use sometimes. Although when I just couldn't be bothered or I can't find anything suitable I grab the middle of the wire, and yank out and down. Not recommended. Doesn't always work and can result in skinned knuckles.
If at first you don't succeed. Build, build again.
Vehicle: 1975 Special order delivery walkthrough panel based LCA pop-top camper. Motor: Nippon 1.8L Single port Wasserboxer, Transmission: 3 rib 002.