Knobs and Ignition Switch

bearwin Casual Dubber

21 posts · joined Apr 2008 · 22 May 2009, 6:49 pm

#713989

guys there are two knobs on the dash one is for lights and what is the other for? since the wiper motor has switch on it....

what ignition switch should I use? how do you install? pics would be greatly appreciated...

1 attachment · Log in to view

58camper Wolfsburg Wizard

591 posts · joined Aug 2002 · 22 May 2009, 7:41 pm

#713994

On the RHD models it is the left hand side switch that is used as the windscreen washer pump assembly. This pump assembly is as CB specific part number and I have never seen a new one. The right hand pull switch is for the lights. Orginally both of the switches were ivory (Part 111 941 541)
The ignition switch is Type 1 Part #111 905 811C described as Ignition/Starter lock with key. It is attached using a small screw mounted on the removable pod where the speedo and switches are mounted.
Where abouts are you located Bearwin.?????
countrybuggybill

ztnoo Insano Dub Head

730 posts · joined Aug 2007 · 23 May 2009, 2:07 am

#714052

Bill,
As I recall from the Samba ad last fall (US fall), the ad stated the car was in The Philippines. I do also remeber at that time bearwin was in San Diego, CA, USA.
His profile still reflects that, although it may not be up to date.
http://www.thesamba.com/vw/forum/profile.php?mode=viewprofile&u=35842

I'm curious as to were the car is. Is it still in The Philippines, or has maybe it be sent to the USA???

Regards,
Steve

Fine tuning the proper daily ratio of Maxwell House to Bacardi 151.........

* Don't worry about the world coming to an end today. It's already tomorrow in Australia !

bearwin Casual Dubber

21 posts · joined Apr 2008 · 24 May 2009, 12:35 am

#714188

the car is still in the philippines, as my homeland, it will stay there for a while....