Does someone have intstructions or pictures for a swingaxle?
Trying to figure out what needs to be undone at axle ends 🤪
trickysimon 100km/h is only 9 seconds away
1,473 posts · joined Dec 2007 ·
Remove Gearbox?
trickysimon 100km/h is only 9 seconds away
1,473 posts · joined Dec 2007 ·
Never mind, managed to clear away enough muddy oil to see what I was doing 😁
dpradford Learner Dubber
19 posts · joined Feb 2009 ·
I'm having the problem you had, but since you figured it out can you (or anyone else) help me out? I have the starter and clutch cable off but I'm not sure what is supposed to happen with the axles. Tried a few things but none worked, obviously.
trickysimon 100km/h is only 9 seconds away
1,473 posts · joined Dec 2007 ·
Ok this might not be the easiest way but this is what I did.
Make sure you have drained the oil and then:
1. Undo bolt at bottom of shock
2. Undo two? bolts holding spring plate to axle tube. You should be able to pull axle tube backwards out off spring plate now
3.Take off the axle nut so you can get the drum off
4. Push out tab holding brake line to axle tube and unbolt brake line from back of drum brake. (I did not need to undo handbrake)
5. Undo the four nuts holding the backing plate to the axle tube and pull backing plate away from tube (Have a rag handy, oil will pour out here)
6. Repeat for opposite side
7. Loosen off two bolts holding in front mount and undo the big bolts holding the rear gearbox cradle in
8. Go in under back seat and unscrew inspection plate
9. Cut tie wire and unscrew the square looking bolt. This should disconnect shift linkage
10. Grab clutch cable with some vise grips and turn wing nut off
11. Dont forget to unplug reverse wire at the front and unbolt ground off gearbox.
12. You should then be able to pull gearbox backwards and then lift it out (weighs 50kg with tubes and axles connected so you might need a jack depending how strong you are 😎)
Make sure you have drained the oil and then:
1. Undo bolt at bottom of shock
2. Undo two? bolts holding spring plate to axle tube. You should be able to pull axle tube backwards out off spring plate now
3.Take off the axle nut so you can get the drum off
4. Push out tab holding brake line to axle tube and unbolt brake line from back of drum brake. (I did not need to undo handbrake)
5. Undo the four nuts holding the backing plate to the axle tube and pull backing plate away from tube (Have a rag handy, oil will pour out here)
6. Repeat for opposite side
7. Loosen off two bolts holding in front mount and undo the big bolts holding the rear gearbox cradle in
8. Go in under back seat and unscrew inspection plate
9. Cut tie wire and unscrew the square looking bolt. This should disconnect shift linkage
10. Grab clutch cable with some vise grips and turn wing nut off
11. Dont forget to unplug reverse wire at the front and unbolt ground off gearbox.
12. You should then be able to pull gearbox backwards and then lift it out (weighs 50kg with tubes and axles connected so you might need a jack depending how strong you are 😎)
Joel Now containing 100\% E-Wang
9,368 posts · joined Feb 2006 ·
add to that d/c clutch cable, starter wiring and reverse light wiring 😉trickysimon wrote:Ok this might not be the easiest way but this is what I did:
1. Undo bolt at bottom of shock
2. Undo two? bolts holding spring plate to axle tube. You should be able to pull axle tube backwards out off spring plate now
3.Take off the axle nut so you can get the drum off
4. Push out tab holding brake line to axle tube and unbolt brake line from back of drum brake. (I did not need to undo handbrake)
5. Undo the four nuts holding the backing plate to the axle tube and pull backing plate away from tube (Have a rag handy, oil will pour out here)
6. Repeat for opposite side
7. Loosen off two bolts holding in front mount and undo the big bolts holding the rear gearbox cradle in
8. Go in under back seat and unscrew inspection plate
9. Cut tie wire and unscrew the square looking bolt. This should disconnect shift linkage
73 on cars dont need anything undone in the front mount
it comes out with the gearbox
trickysimon 100km/h is only 9 seconds away
1,473 posts · joined Dec 2007 ·
Yeh quick reply wouldnt let put any more lines in so I was editing it 😉
dpradford Learner Dubber
19 posts · joined Feb 2009 ·
Thanks for your help Simon, followed your instructions and had no problems, much appreciated.
trickysimon 100km/h is only 9 seconds away
1,473 posts · joined Dec 2007 ·
No worries mate 👍