12V genny fan rub

karmann54 Officially Full-On Dubber

337 posts · joined Nov 2002 · 5 Feb 2011, 4:54 am

#824853

I'm converting my '67 beetle to 12V, and when I've mounted the fan on the genny shaft there is a rub between the back of the fan and the backing plate.

The fan is mounted onto the hub with no washers/spacers at back. At the front there is a washer and lock nut. The 'washer' is a special with the cut-out to suit the drive shaft.

My question is, should there be spacers between the hub and the shaft to shift the fan axially out along the shaft and thus clear the backing plate. My feeling is it's more likely my backing plate is a little warped but just wanted to check before I start any panelbeating on it - I've only got one!

Thanks, Angus

Joel Now containing 100\% E-Wang

9,368 posts · joined Feb 2006 · 5 Feb 2011, 7:47 am

#824860

Are all the shims missing?

There should be half a dozen or so, same as the pulley has, the unused ones go on the front side under the nut.

Needs to be spaced out so it sits in the center of both the shroud and the backing plate.

karmann54 Officially Full-On Dubber

337 posts · joined Nov 2002 · 5 Feb 2011, 7:53 am

#824862

Joel

Thanks for that. There were no shims at all. When I pulled apart another genny/fan I had this morning it had a single shim, but it is still not enough.

Now knowing there should be half a dozen or so makes it simple.

I'll dig around to see if I have any lying around. I didn't even know I had this other genny and fan, it's amazing how VW crap seems to accumulate....

68AutoBug Beetle Restorer - Experience over 138\% - YIKES --

11,654 posts · joined Aug 2002 · 5 Feb 2011, 9:46 am

#824874

karmann54 wrote:I'm converting my '67 beetle to 12V, and when I've mounted the fan on the genny shaft there is a rub between the back of the fan and the backing plate.

The fan is mounted onto the hub with no washers/spacers at back. At the front there is a washer and lock nut. The 'washer' is a special with the cut-out to suit the drive shaft.

My question is, should there be spacers between the hub and the shaft to shift the fan axially out along the shaft and thus clear the backing plate. My feeling is it's more likely my backing plate is a little warped but just wanted to check before I start any panelbeating on it - I've only got one!

Thanks, Angus

should be heaps of shims....
the spare ones are kept under the nut and washer
every generator had them..

Lee

- Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY---