Skip to content
Aussieveedubbers

Looking for small front cut for my 70 lowlight panel

0 likes
Share Share on Facebook Share on X Share on Reddit
Log in to reply

rossdanialnaumov Officially Full-On Dubber

230 posts · joined Jan 2011 ·

#830806
Hi guys,

I need this section for my 1970 lowlight panel. I started cutting the rust from the lower windscreen and i turns out it's had a hit right in the centre -- a heap of bog!

This is the section i need. I really only need about 2 inches down from the lower windscreen but it will be easier to join/ weld it at the air vent. Can anyone help?

See image here: http://rossandkim.com.au/window.jpg

rossdanialnaumov Officially Full-On Dubber

230 posts · joined Jan 2011 ·

#830810
Yes but it curves both ways. I guess i can try but it would be easier if i had a cut as i know it will fit straight in.

Special Air Service Chief "Gunna"

1,769 posts · joined Oct 2004 ·

#830821
I "might" have this section, as well as the wheel well you where chasing earlier?

They are attached to an early lowlight at my oldies place, so I might not be able to check for about a week & a half.

I'm at Taree NSW, so obviously if you get one closer it would be easier for you. Let me know if your interested.

Cheers
Brendan
Calling all NSW Mid North Coast Veedubbers

Click Below
Mid North Coast VW

rossdanialnaumov Officially Full-On Dubber

230 posts · joined Jan 2011 ·

#830826
Hi Brendan,

Thanks mate. Yes i'm interested. Can you let me know if these are available. I'm back working on the car in about 4 weeks so i'd like to have them by then.

Cheers,
Ross

Special Air Service Chief "Gunna"

1,769 posts · joined Oct 2004 ·

#834673
Ross, check your PM box, I may be able to get these cuts for you this weekend.

Cheers
Brendan
Calling all NSW Mid North Coast Veedubbers

Click Below
Mid North Coast VW