| [ Total Views: 904 | Total Replies: 3 | Thread Id: 86503 ] |
|
|
 kombiute
Casual Dubber
Posts: 30
Threads: 15
Registered: October 9th, 2006
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 11th, 2010 at 03:55 PM |
|
|
Stud Pattern and Offset size
Hello,
I have a 1971 Dual Cab Kombi Ute and was wondering what the Stud Pattern and Offset size would be? as I would like to get some after market wheels for
it.
Thanks in advance
|
|
|
mackaymanx
A.k.a.: Brent
Custom Title Time!
Posts: 1611
Threads: 97
Registered: January 12th, 2006
Member Is Offline
Location: Mackay.QLD
Theme: UltimaBB Pro Blue
Mood: Brad'ed Off 
|
| posted on October 11th, 2010 at 04:03 PM |
|
|
PCD is 5 x 112 mm
Off set should be 41 mm
Quote of the week
"Do I wish to send them to you again, nope, no interest can't be bothered really, to much hassle for little or no return."
 |
|
|
kombiute
Casual Dubber
Posts: 30
Threads: 15
Registered: October 9th, 2006
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 12th, 2010 at 11:46 AM |
|
|
I am very keen to go to a 17 inch Early Streeter look for my wheel on the Ute. The only wheels I can find with the most common offset is 5 x 114.3
(Ford). It has been suggested that I can get the Flange plate drilled to accomodate in the front (Disc Brakes) and Im changing the back to a Disc
Brake Set up.
Appearently the drilling of the Flange is straight forward and wouldnt cost too much, is anyone aware who can help me with this service in the Mascot
area? also has anyone done this before who can comment or offer advise?
Thanks agian.
|
|
|
pete wood
A.k.a.: figure itout
23 Windows of Awesome
Posts: 6828
Threads: 389
Registered: January 15th, 2004
Member Is Offline
Location: Nth Nth StMarys, Sydney
Theme: UltimaBB Pro White
Mood: upgrades = jackstands
|
| posted on October 13th, 2010 at 02:04 PM |
|
|
just make sure there is no welding/spot facing going on. that is strictly a no no in NSW. I gather the new holes are going in between the old ones.
Also, just check that where they are going in has enough meat to accommodate them. sometimes there are webs of extra metal behind lugnut holes.
any engineering machine shop should be able to put the holes in.
|
|
|
