Posts: 124
Threads: 341
Registered: August 27th, 2002
Member Is Offline
Location: brisvegas
Theme: UltimaBB Pro Blue ( Default )
posted on September 12th, 2003 at 04:28 PM
type 3 engine lid into a kombi
hey
im just about to put in the V6 and need this in the engine area
has anyone got any pics of theres in the rear of there kombi???
how much have you cut out etc?
cheers
rhys
it aint just cool its aircool'd
Desert Bug
Wolfsburg Wizard
Posts: 687
Threads: 72
Registered: August 28th, 2002
Member Is Offline
Location: Bendigo Victoria.
Theme: UltimaBB Pro Blue ( Default )
Mood: NOW VERY HOT AND HUMID!!!
posted on September 12th, 2003 at 11:23 PM
Rhys,
have a look under the floor above the engine and you'll see a square section running down both sides and across in front of the fuel tank cover
and across the back above the engine lid. If you cut around against the flat bit where it is spot welded to the floor above you will find that a Type
3 engine cover section cut out with about 2.5 cm around the outside will fit in perfectly. This is what I did with mine.
Ian.
