| [ Total Views: 516 | Total Replies: 4 | Thread Id: 49307 ] | 
|  | 
|  jeremy 
 
Seriously Crusin Dubber
    
 
 
Posts: 156
 
Threads: 37
 
Registered: September 21st, 2005
 
Member Is Offline
Location:  QLD
Theme:  UltimaBB Pro Blue ( Default )
Mood:  Tired
 | 
| posted on February 26th, 2006 at 09:05 PM |  |  | 
| Reversing light 
 
 The reversing light on my '77 Kombi stays on most of the time and goes out ( I am told) after and few kms down the road or after 1/2 a dozen or so
gear changes.
 
 Are they able to be adjusted or would this more likely be a dud switch?
 
 and
 
 if I remove the switch to replace it will this drain the gearbox oil?
 
 Its a manual transmission
 
 Jeremy
 
 [ Edited on 26-2-2006 by jeremy ]
 | 
|  | 
|  Bizarre 
 
Super Moderator 
The artist formerly known as blue74l
         
 
Posts: 12780
 
Threads: 734
 
Registered: August 25th, 2002
 
Member Is Offline
Location:  Abbotsford, Sydney
Theme:  UltimaBB Pro Blue ( Default )
 | 
| posted on February 26th, 2006 at 09:13 PM |  |  | 
| 
 
 is it an auto or manual??
 
 
 
 
 Futue te ipsum!!! | 
|  | 
|  jeremy 
 
Seriously Crusin Dubber
    
 
 
Posts: 156
 
Threads: 37
 
Registered: September 21st, 2005
 
Member Is Offline
Location:  QLD
Theme:  UltimaBB Pro Blue ( Default )
Mood:  Tired
 | 
| posted on February 26th, 2006 at 09:24 PM |  |  | 
| 
 
 Its a manual transmission
 | 
|  | 
|  1303Steve 
 
A.k.a.: Steve Carter 
Scirocco Rare
           
 
 
Posts: 8650
 
Threads: 564
 
Registered: August 27th, 2002
 
Member Is Offline
Location:  Sydney, NSW
Theme:  UltimaBB Pro Blue ( Default )
Mood:  Parrot Heading
 
 | 
| posted on February 26th, 2006 at 11:45 PM |  |  | 
| 
 
 Hi
 
 The switch may be gummed up, try taking it out and soaking it in WD40.
 
 Steve
 | 
|  | 
|  vw54 
 
Super Administrator 
Always Waiting 4 Friday
           
 
Posts: 16723
 
Threads: 378
 
Registered: August 26th, 2002
 
Member Is Offline
Location:  Sunny Sydney
Theme:  UltimaBB Pro Blue ( Default )
Mood:  Oval resto ongoing
 | 
| posted on February 27th, 2006 at 05:48 AM |  |  | 
| 
 
 You can undo the switch and put a bit of masking tape over the hole to stop the oil running out while you clean the switch and check or replace it.
you wont loose much oil  or park the van slightly up hill so the oil run away from the switch hole.
 
 
 
 
 | 
|  |