Quote:
"Brad, I have seen the Club Shop, and the prices are very good.....but when the dash looks like a cockpit....... "
------------------------------------------------------
Fitted the wiring loom tonite, it went in a lot easier than I thought it would. Drilled all the holes into the tubes leading to the front & rear and pulled all the wires through. We had to make a panel to monut all the wiring & fuse blocks under the bonnet, this has a drop down door for easy access to the fuse blocks. We start the barwork on the weekend, should be fun.
Here is a pic of the front & middle bars we bent up on the weekend. Just a test run to make sure they fit, which they did. We will have them welded and fitted this weekend if all goes well. (Wiring.. Thanks to Brad) Yes Daz the wiring went well lucky to Brads super human knowledge & eagerness to work into the night we got it figured out. I still have a few ends to tidy up but it should be ready to start next week.
Here is the wiring loom once it has been all tidy up. The fuse panel it mounted on a drop down board for easy access. The bonnet is now screwed down and fingers crossed it will not have to be taken off in the near future.
