Skip to content
Aussieveedubbers

T3 extractor question

0 likes
Share Share on Facebook Share on X Share on Reddit
Log in to reply

Dannyboy half man , half horse

2,306 posts · joined Jan 2004 ·

#272868
Have a question on t3 extractors. Once bolted to the motor and in the car how far does the extractor flange sit from the rear apron ( valance).
I'm getting a custom muffler made up and need a rough measurement.

cheers Dan
"If i had to explain you wouldnt understand"

The Lower Class

DallanMulley Seriously Crusin Dubber

145 posts · joined Apr 2004 ·

#274586
Just gone and measured my 62 the flange is 30 mm but the silencer pipe comes out lower than the apron.

Dannyboy half man , half horse

2,306 posts · joined Jan 2004 ·

#274661
What car have you measured it from and roughly how much lower is it. Could you run a Stinger or would you need a cut out in the apron?

Cheers , thanks for being bothered!

Dan😉
"If i had to explain you wouldnt understand"

The Lower Class

frenzix Son of Jim - Creator of Good

2,742 posts · joined Dec 2003 ·

#274703
on the 69square, my stinger fits fine.. clears the apron...
www.nkcrew.com.au

Dannyboy half man , half horse

2,306 posts · joined Jan 2004 ·

#274722
T3 stinger , Frenzix are you pulling my pud? Never heard or seen one.

Dan😉
"If i had to explain you wouldnt understand"

The Lower Class

Dannyboy half man , half horse

2,306 posts · joined Jan 2004 ·

#275032
LOL , bloody knew it!

Dan😉
"If i had to explain you wouldnt understand"

The Lower Class

shiftyvw Wolfsburg Wizard

523 posts · joined Sep 2002 ·

#275073
If your planning on using a stinger im assuming this is a hot motor. Where are you getting big headers from. I had to build my own 1 7/8 system when I put the 2.3 with IDA's in the squareback.

Dannyboy half man , half horse

2,306 posts · joined Jan 2004 ·

#275109
shiftyvw wrote:If your planning on using a stinger im assuming this is a hot motor. Where are you getting big headers from. I had to build my own 1 7/8 system when I put the 2.3 with IDA's in the squareback.

LOL i wish!!! It's only a 1776 with 44's , nowt fancy . The headers are only 1 5/8 which will be okay for now i reckon.

Dan😉
"If i had to explain you wouldnt understand"

The Lower Class