Ok... that all looks a bit confusing to me (hence the title of the thread😉). So like you said i'll get an engineer to do it. I'm in Adelaide so i have no idea what V-force is???
cheers
v-force is a company in sydney they can supply the disc & drums drilled in any PCD you want. pcd,s 4x100 is common in smaller cars or 5x114.3 in larger cars any 3peice wheel will cost from $700 up each simmons and roh can make a 17x6 or 17x6.5 with any ET so you wont have any clearencing issues. Enkie make high quaulity 1peice alloy wheels in a wide size range and pcd,s, et,s are good to as well as the weight eg 17x7 weighs 6.5 kg.
Are you saying $700 for each rim custom made or for redrilling standard/new drums? I dont want to go sending off my drums to sydney to get them drilled when i could get it done here... i don't see the point.
cheers
$700+ per 3peice rim not pcd,s redrilled
Yeah i didn't think it would cost so much for redrilling drums... Like i said before i think getting rims custom made is pointless because then i can't change them later i have to get them custom made again. Gonna cost me an arm and a leg for that... i might as well spend say... 100 bucks to get them redrilled? We know HEAPS of people that would probably do them for next to nothing BUT probably not as accurate as if an engineer was to mark it out and drill them himself...
anyway cheers guys.
