Skip to content
Aussieveedubbers

crankshaft end float ????

0 likes
Share Share on Facebook Share on X Share on Reddit

deluxe hunter Casual Dubber

48 posts · joined Feb 2004 ·

#327592
I'm assembling a new engine (1600 type 1) and about to fit the flywheel. I have measured the endfloat to be 0.65mm. I understand three shims must be used and they come in a number of sizes from 0.24mm - 0.36mm. The assembled end float should be 0.07 - 0.13mm. So for minimum end float I need 0.65 - 0.07 = 0.58mm worth of (3) shims.

Well this aint possible with three shims.....

Any clues or ideas of what is up????? Can I use two shims???

Bizarre Moderator The artist formerly known as blue74l

12,797 posts · joined Aug 2002 ·

#327615
did you get a new thrust bearing cut in???

Sounds like you need to get the case machined and a new thrust bearing put on??


But..... have you fitted the fly wheel???

Aint you suppose to measure end play with the fly wheel on???

Che Castro ankle straps

1,945 posts · joined Aug 2002 ·

#327716
the flywheel has to be fitted and the gland nut torqued to 300ft/lbs, then you can start measuring the end play, which you either use a dial gauge or a special tool which lets you use feeler gauges.

You should be using 3 shims, it acts as a sort of buffer between the rotation of the flywheel and the thrust surface on the #1 bearing.
Jon

vw54 Administrator Always Waiting 4 Friday

16,723 posts · joined Aug 2002 ·

#327772
did u fit new main bearings as Barry said....

fit the flywheel to the crank without seal or shims then check the total end float...
I read it on FACEBOOK so it must be true


http://forums.aussieveedubbers.com/viewtopic.php?tid=91278&page=1#pid848630


http://forums.aussieveedubbers.com/viewtopic.php?tid=63561&page=1#pid624099


http://forums.aussieveedubbers.com/viewtopic.php?tid=4832&page=1#pid452603


http://forums.aussieveedubbers.com/viewtopic.php?tid=60650&page=1#pid574409

deluxe hunter Casual Dubber

48 posts · joined Feb 2004 ·

#327824
Thanks for the replies.

A bit more info. I have used a new empi aluminium case and a 74mm stroke crank. New std bearings - which fitted well.
I did fit the flywheel, although I didn't fully tourque it up - just a firm nip-up. (if it was not tight enough I guess the end float would be increased)

I measured the end float with a dial indicator clamped to the flywhel and measured it on the case/gearbox flange. No seal fitted.

vw54 Administrator Always Waiting 4 Friday

16,723 posts · joined Aug 2002 ·

#327835
I suggest you go along to a VW shop and have it checked out
I read it on FACEBOOK so it must be true


http://forums.aussieveedubbers.com/viewtopic.php?tid=91278&page=1#pid848630


http://forums.aussieveedubbers.com/viewtopic.php?tid=63561&page=1#pid624099


http://forums.aussieveedubbers.com/viewtopic.php?tid=4832&page=1#pid452603


http://forums.aussieveedubbers.com/viewtopic.php?tid=60650&page=1#pid574409