sub60 Seriously Crusin Dubber
137 posts · joined May 2005 ·
Just wondering if anybody has grafted a rack and pinion set up on to a ball joint front end and if so what was the donor unit,CHEERS
rack & pinion
71superbug The Itch Itcher
1,184 posts · joined May 2004 ·
from what i remember i think there was a discussion somewhere about using the Rack and pinion from a CAMIRA.
not sure if this was for ball joint or strut front end though.
but in memory this was the only reasonable option mentioned in the discussion.
Vforce do a rack and pinion with a 1.1:1 ratio if you want to race 😀
Anthony
not sure if this was for ball joint or strut front end though.
but in memory this was the only reasonable option mentioned in the discussion.
Vforce do a rack and pinion with a 1.1:1 ratio if you want to race 😀
Anthony
sub60 Seriously Crusin Dubber
137 posts · joined May 2005 ·
Thanks Anthony will look at that option CHEERS
BiX Veteran Volks Folk
2,499 posts · joined Sep 2002 ·
try the tech mods section, and also i think wes ended up doing a 3d models to see how much bump steer would occur
I have no sympathy for my car, only the wallet that pays for it!
Go hard or go home!!!!
Go hard or go home!!!!
71superbug The Itch Itcher
1,184 posts · joined May 2004 ·
if you are going to be driving this on the street i would probably reccoment not using the one from vforce..simply because of its ratio.
Anthony
Anthony
seagull Compulsive Aussie Vee Dubber
4,979 posts · joined Dec 2003 ·
I am looking at fitting my subaru unit from the front cut on mike , I think you would do the same , neil
Looking for that special lady : PM me for coffee & cake