Clearance shouldnt be too much of a problem, im running a little lower than stock height, but i want to keepo the stock look.
I really wanted something that would exit through the stock holes but id rather the performance
Is the one advertised the empi version?
Sometimes the CVD ads are very confusing, but its the only place with the info :p
these are the tuckaways matt mentioned
theyre essentually a quietpack but the muffler sits up under the gaurd instead of hanging down below
staino version is on special atm
🤓
Should get my mitts on them asap then!
$400 bucks for that in s/s has to be the one to buy. Heaps better than the std qp location.
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
I just ordered it, such an impulse buy :P
Is it still possible to use the heater systems with the high mount?
Yep, heater boxes are retained with the one in the pic.
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
Oh kewl! Lucky, its getting damn cold, having a scarf doesnt help that much in a convertible :p
TrickySimon/Milestones,
The inlet manifold centre section can be found on some bus motors too. If the carby says 34 Pict...that's the reason I say semi-auto because of the vacumm take-offs + manifold.
You won't find that particular 34 Pict carb on a bus motor unless it's a H30/31 instead of a 34 Pict.
Regards
Ctefeh
its a 34pict3, 31s have a much smaller base
its a bitsa motor and not the original, evident by the lack of an engine number
one of mine is all the same but only cos i put a manifold off a bay on it which has the semi auto port for the brake booster and the carb had the retard ports blocked off
this may be a bit late but if you can weld things together.. or get exhaust custom made here's some ideas
this is actually what "quiet" system is with 2 resonators and a lukey muffler all 1 3/4" all you can hear is the fan and induction noise of twin solexes. see that the ground clearance is bad it's like 4" off the ground. but it's nice for everyday driving cost me about 150 for the 2 res and a muff
and the other is the show set custom made with steelwool filled sound like canon on a commodore and loud cost me $10 for a roll of fine steel wool
Cant steel wool catch on fire???
Only if you put a current through it.
Nice job!
Im guessing it fits ok in the wheel arches
I dont so much want it quiet, just a different exhaust note
there you go. i thought it was heat as well. clearly not.
wow blast from the past, a 2 bolt kadron header,
i once had a dinosaur exhaust system too 😂
iv got kadron 2 bolt on my bug too
i've seen steel wool ignite just from sun through laser light.. trust me that shit goes up..
hth
Peter Hill
1975 Type 2 Double Cab
modulus.com.au
