Beetle stuff for sale

tdegens Wolfsburg Wizard

425 posts · joined Apr 2004 · 6 Feb 2011, 5:05 pm

#825099

Early Fuel tank with reserve tap $70. Chromed Generator which has the inside coil loose chrome is ok $60. Beetle Motor - F number - that was line bored by Garry Moody. The case was cleaned and checked and the crank measured and the bearings supplied by north coast engines The top end was ok with good power and no oil burning. The heads were good. $200.
Metho cooka $40 should work never used it. Looks simple enough gravity feed metho. Water Pump Homda 5.5 hp $60 goes. Also a fasty tank $40. I also have a 73 Fasty with a working complete motor in place. Good gearbox. Doors, seats, dash gone $500. I can email picies pickies wont load being 124k
Pick up or post with fastway
Tom Degens emerald beach NSW 2456 0266562864 0458562865 tdegens@gmail.com

baghall Ben Hal Outlaw Bushranger

1,021 posts · joined Jan 2010 · 6 Feb 2011, 9:16 pm

#825153

What type of gearbox is it?

68 Baja - It's a growing pain!
58 Baja ute - and the pain spreads!
85 T3 Kombi - still growing
89 T3 Kombi - parts car

pickstock Seriously Crusin Dubber

107 posts · joined Dec 2010 · 6 Feb 2011, 10:05 pm

#825171

is the engine running? what does F engine detail (single port, size etc)

does anyone else know shipping to SA??

tdegens Wolfsburg Wizard

425 posts · joined Apr 2004 · 10 Feb 2011, 6:35 pm

#825707

The motor is crankcase assembled and pcband head sitting in place. Th etinware and exhaust etc needed. New bearings good crank, linebored case.
The gearbox is 1973 standard fasty.

Calcool Fahrvergnugen

965 posts · joined May 2005 · 13 Feb 2011, 7:01 am

#826101

Can you post some pics of the engine.

I am a bit confused, was it recod and the piston and barrels not fitted up yet, nor the heads?

How long since it was assemled? does it have its flywheel and has this been fitted and end play set?

Are you coming to Brisbane anytime soon?

Cheers,

David

0434 58 22 64

tdegens Wolfsburg Wizard

425 posts · joined Apr 2004 · 13 Feb 2011, 10:22 am

#826128

the flywheel is not on, the
pistons barrels and heads are on but not tight. no tinware just bottom end assembled with new bearings and linr bored. cost me $300 so out it goes for $200

hellbugged 48's and straight cuts

5,080 posts · joined Apr 2003 · 13 Feb 2011, 11:50 am

#826148

so fasty motor is running and complete?

what state of health is it in?